Agricultural Mixed Flow Pump

Overview

Our Agricultural Mixed Flow Pump is suitable for transporting clear water or other liquids with physical and chemical properties similar to water. It is widely used in farmland drainage and irrigation, industrial and urban water supply and drainage and other occasions. It has long service life, uniform overheating and strong power. Its shaft sealing device uses packing sealing structure, which can prevent air from being sucked into the pump and water from flowing out along the shaft too much.

Our Agricultural Mixed Flow Pump is a centrifugal pump with a mixed flow impeller (also called diagonal impeller), and their application range covers the transition gap between radial flow pumps and axial flow pumps. The utility model has the advantages of simple structure, reliable use, convenient assembly and disassembly, small size, light weight, large flow and high efficiency. Cast iron shell, good heat dissipation effect, durable, improve the operation capacity of the pump. It uses spray painting technology, soft color, beautiful and generous.

Installation steps of agricultural mixed flow pump：

1. Check all the parts of the agricultural mixed-flow pump, such as the inlet and outlet pipes, elbows, rubber gaskets, screws and nuts. And clean the section of the water pipe, check the position of the hole and the size of the matching screw.

2. Install the bottom valve at one end of the pipe, and choose an appropriate length according to your needs. Install the elbow joint on the other end of the pipe. This is the installation of the inlet section, there are two ways, vertical and inclined installation.

3. Then clean the water inlet of the agricultural mixed-flow pump, and install the fixed half ring. It divides a circle into two parts and installs it twice, so install half of it first.

4. Then connect the inlet elbow and the inlet section of the agricultural mixed-flow pump to install. It is necessary to move the position of the agricultural mixed-flow pump and the position of the inlet section to meet the requirements of using screw links.

5. When the inlet section and elbow of the agricultural mixed-flow pump are in the proper installation position, install the remaining semicircular snap ring, and pay attention to the rubber gasket at the connection between them. Then connect and fasten the components with screws and nuts.

6. When the inlet pipe of the agricultural mixed-flow pump is also installed, the overall position is fixed, and the base can be fixed at this time. Connect the water outlet pipe to the water outlet of the agricultural mixed-flow pump. The position of the outlet pipe can be changed through the elbow.

7. The installation of the entire agricultural mixed-flow pump is completed in this part. At the same time, the motor is also installed at the connection of the agricultural mixed-flow pump. Such a complete agricultural mixed-flow pump is installed!

http://www.sdbestu.com/